With the system to be installed in the boot of the vehicle, a new airbox was fabricated to house the air filter. It will be located in the right rear corner of the boot. The airbox was fabricated out of 3mm aluminium sheet and TIG welded.
Two 3 inch aluminium tubes were added to the airbox for the air intake.
An additional single 3 inch aluminium tube passes through the side of the airbox allowing a K&N pod air filter to be mounted inside. This will supply filtered air to the inlet of the compressor. A K&N dry charger air filter wrap was installed over the pod filter and a drain added to the bottom of the airbox to ensure free water does not enter the intake of the compressor. This side of the airbox is removable allowing the air filter to be serviced.
